I created my action figure using fusion 360. First, I used a center rectangle to make the head. To make a head I extruded the center rectangle and used the fillet option in modify to make the edges curve. Then I moved the ball joint which I created before to this design and put the ball part on the head part. Then I used center diameter circle to make a hat of the action figure. So, I chose the option center diameter circle and extruded and in a new sketch I made a center diameter circle bigger than the first one and extruded it and I added the other part of the ball joint to the hat so I can connect them. To make the eyes I used center diameter circle and extruded it and added the peg on the bottom of the eye. To make the body I used a center rectangle to make the body of the action figure and make another center rectangle for the legs and made a hole in it by using the option hole and made a cylinder through that hole to attach the legs. I made legs by extruding cylinders. I made hands by using the cylinders and extruding and adding the ball joint to the ball part with the body and another part on the hand.