This assignment consisted of taking a flat SVG image and extruding it to be three dimensional. I chose the simple Pokemon logo to extrude.
Step 1. Import the SVG file into Fusion 360
Step 2. Sketch a 2 point rectangle around the logo so it is completely enclosed. No lines in the logo should be intersecting the outer rectangle.
Step 3. Using the fillet feature, round each edge of the rectangle so that the fillet measure is 10 mm.
Step 4. Select all of the letters in the logo and the accent above the e and extrude 5 mm.
Step 5. Select the border around the letters and extrude 3 mm. Then select the rounded rectangle and extrude 1 mm.
Slicer: Cura 3.0
Layer Height: 0.2 mm
Infill Density: 20%
Nozzle Size: 0.4 mm
Estimated Material: ~9 g
Estimated Print Time: 2.5 hours
Files for this print can be found here.